Can Double Cell Light Filtering Shades Be Restrung

Introduction

It is important to know how to restring cellular shades due to article of clothing and tear from house pets, small-scale children, and accidental damage. This guide outlines an easy repair for cleaved or worn strings that can exist done at home instead of completely replacing the shade.

Unscrew the tassel and set aside.

Unscrew the tassel and fix aside.
Using a flathead screwdriver, open the string stop, remove from the strings, and set aside.

Close the shade and push up, sliding the shade out toward the center of the room.

Close the shade and push up, sliding the shade out toward the center of the room.
This is a common method for taking down a cellular shade but non all shades are hung the same mode. Utilise the appropriate method for your shade.
Identify the shade on a apartment surface to work on.

Measure out and cut the new nylon strings. To exist safe, the length should be equal to the sum of the window width and twice the window height. There will exist excess cord and it will be cut off in stride 14.
Length = (Window Width) + ii*(Window Height)

Use the flathead screwdriver to take the end caps off of the superlative rail and set up bated.
Take out the spiral using the phillips screwdriver and slide the top rails off.
Using the needle olfactory organ pliers, push the cord lock clips in from the side and slide the cord lock out, removing the strings and setting the cord lock aside.

Flip the shade over and pull the end caps off of the bottom rail. Set them bated.
Slide the bottom runway off and gear up bated.

Untie the ends of the strings between the weights on the bottom of the shade.
Pull the strings out of the shade and discard.

Thread the new string through the restringing needle.
Pull the needle and thread through the shade, making sure to leave 3 inches out of the lesser side of the shade.
Repeat for the other strings.

Tie a knot with the 3 inch piece and pull the string tight.
Repeat for the other strings.

Slide the bottom runway back onto the shade.
Button the bottom end caps back onto the rails.

Plow the height track over and then that the top is on the work surface.
Thread the strings through the small gap in the acme rail that the cord lock was removed from.
The ends of the strings should be on the outer side of the top track.

Restring the cord lock by starting time picking upwards the strings coming out of the string lock gap. Thread them through the side opening of the string lock and out of the back opening.
Thread them back through the back opening and out of the front opening. Make certain to pass the strings through the black rectangular piece inside the string lock.
Pull the strings tight and so that the strings are only in the front and side openings.

Insert the cord lock into the gap in the peak rail with the opaque plastic side facing upwards.
Lay the strings down the middle of the shade.
Slide the tiptop track onto the shade, pulling the strings tight through the cord lock.
The finish of the rail without the cord lock should be slid on first.

Use the phillips screwdriver to put the screw back into the top runway.
Push the finish caps back into place.

Rehang the shade past pushing the shade upwards into the clips and sliding it towards the window.
This is a common method for rehanging cellular shades but not all shades are hung the same mode. Use the appropriate method for your shade.
Open up the shade and cut the strings then the ends are halfway up the shade.